![]() ![]() Stop and Restart Trajectory from Start Point NOTE: Spread is Logarithmic, 14% is Optimal for Most Cases X and Y Value of the Panner Position within a SpacemapĬrossfade Value Between Two Spacemaps on a Channel Step 6: GENERAL PURPOSE OSC: toggle the ENABLE slider to ONīelow are the General Purpose OSC commands that a Spacemap Go system will respond to. In the instance that an event in SMG needs to trigger a QLab event, set the port number to 53000 – the default Rx (receiving) port used by QLab. Step 5: GENERAL PURPOSE OSC > PORT: Leave the port set to default, (0). ![]() NOTE: When an IPv4 address is entered, QLab will only listen for commands from the device with that IPv4 address. Step 4: GENERAL PURPOSE OSC > IPv4 ADDRESS: leave set to the default, (any). Step 3: SYSTEM IP CONFIGURATION > SUBNET MASK: Enter a system subnet mask, usually, 255.255.255.0. Do not use or allow the Spacemap system to create duplicate IPv4 addresses on the network. NOTE: Ensure the range of IPv4 addresses is available on the network. These addresses are independent of the IPv4 addresses listed in Compass software on the PROCESSORS > SETTINGS > NETWORK tab. Following that address, a contiguous range of IPv4 addresses for each Spacemap Go GALAXY processor is automatically assigned. NOTE: Spacemap Go uses this IPv4 address as the master IPv4 address of the system. Step 2: SYSTEM IP CONFIGURATION > IPv4 ADDRESS: Enter a system IPv4 address, in the same subnet of the computer running QLab. ![]() Step 1: In the Spacemap Go app on the iPad, tap SETTINGS VIEW (bottom), then SYSTEM SETTINGS > EXTERNAL DEVICE CONTROL. The Apple computer running QLab must be within the same IPv4 range and subnet as the Spacemap Go System IPv4 address, GALAXY processor(s), and iPad.The Apple computer and the GALAXY processor must be on the same network.Spacemap Go receives OSC commands via port 38033 and QLab receives OSC commands via port 53000.Ĭonnection Steps – Hardware (not Virtual GALAXY) ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |